Hot air heater element for Mlink H5 and H3+ soldering station

The heating element is mainly made from a nickel-chromium alloy for the heating element and a ceramic or insulating metal housing. Standard approximate dimensions are 85 mm long by 14 mm in diameter, although we recommend confirming with the exact model of your Mlink H5 or H3+ station before purchase.

The heating element is designed to operate at a typical rated power of 650 W at 230 V~ (±10%). For safe use, it is not recommended to exceed these parameters, as this could affect the integrity of both the heating element and the station.

To install the heating element, disconnect the soldering station completely, wait until all components are cool, and follow the manufacturer's specific instructions. It is essential to avoid direct contact with the heating element and to check that the terminals are connected correctly. Always use insulated gloves and avoid powering the unit while carrying out the replacement.

Common signs of failure include reduced heat output, intermittent operation or changes in the colour of the heating element. This specific reference can only be replaced by another original Mlink H5/H3+ part, so the same model must be purchased. There are no repairable internal components; the complete part is replaced.

No, this heater element is compatible only with Mlink H5 and H3+ soldering stations and should not be used in other models.

To replace the heater element, it is recommended to follow the manufacturer's instructions or use a specialist technician to ensure correct installation and avoid damage.

Using this original heater element guarantees an efficient hot air flow, extends the station's service life and maintains optimum performance in your soldering work.